Free tools

Well test rate calculator

Convert a volume produced during a test of any length into a rate per day and per hour.

Oil in STB, water in bbl, or gas in scf. The result is in the same unit.

Length of the test. Must be greater than zero.

Formulas

  • Rate per day = Volume / Test duration (hours) × 24
  • Rate per hour = Volume / Test duration (hours)

Worked example

Entered

Volume produced
100 units
Test duration
12 hours

Result

Rate per day
200 units/day
Rate per hour
8.3333 units/hour

Before you rely on it

  • The result is the average rate over the test, scaled to 24 hours. A short test scaled up to a day assumes the well would have kept producing at that average rate.
  • It is not a stabilized-rate determination and applies no meter, shrinkage, or standard-condition corrections.
  • To get oil, gas, and water rates, water cut, and GOR together from one test, use the full calculator.

These results are preliminary and are not certified engineering calculations. They require review by a qualified engineer and independent verification before being used for operational, commercial, regulatory, or safety-critical decisions.

Need the whole well test in one go?

The full calculator takes the test duration and the oil, gas, and water produced, and returns every rate, water cut, and GOR together, with a PDF report.

Open the well-test calculator